PRODUCER:

ISO TRADE Spółka z o.o.
Gniewomierz 173
59-241 Legnickie Pole, Polska

office@iso-trade.biz

RESPONSIBLE PERSON IN THE EU:

IsoTrade

WARNING CONTENT:

- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
- A-weighted sound pressure level is less than 45 dB.
- The device must be disconnected from the power supply during maintenance.
- Always operate the appliance from a power source with the same voltage, frequency and rating as indicated on the product nameplate.
- Always use a grounded electrical outlet.
- Unplug the power cord when cleaning or not in use.
- Do not operate the device with wet hands. Prevent water from spilling onto the device.
- Do not immerse or expose the device to rain, moisture or other liquids.
- Do not tilt or rotate the device.
- Do not unplug the device from the power supply while it is turned on.
- Do not disconnect the device from the power supply by pulling on the power cord.
- Do not use an extension cord or adapter.
- Do not place objects on the device.
- Do not climb or sit on the device.
- Do not insert fingers or other objects into the air outlet.
- Do not touch the air inlet or aluminum fins of the device.
- Do not use the device if it has been dropped, damaged or shows signs of product malfunction.
- Do not clean the device with any chemicals.
- Make sure the device is away from fire, flammable or explosive objects.
- The device must be installed in accordance with national wiring regulations.
- Do not use means to accelerate the defrosting or cleaning process other than those recommended by the manufacturer.
- The device should be stored in a way that prevents mechanical damage.
- Do not crush or burn, even after use.
- Please note that refrigerants must be odorless.
- Pipelines must be protected from physical damage and should not be installed in an unventilated space if that space is less than 4 m2.
- National gas regulations must be observed.
- Keep all required ventilation openings clean.
- The device should be stored in a well-ventilated place where the room size corresponds to the area of the room designated for operation.
- Do not throw away the water tank magnets or plastic rivets. Otherwise, the unit will not stop automatically when the water tank is full, and condensed water will overflow and damage the floor.
- Before resetting the device to its operating mode, clean the condensed water in the water tank.
- If the water tank is dirty, rinse it with clean water. Avoid using detergents, steel balls, chemical dust removers, diesel fuel, benzene, thinners, or other solvents. Otherwise, the water tank will be damaged and leak.
- Place the empty tank back into the device. Otherwise, the water full indicator may remain red and the device may not restart.
- Do not block the drain or drain pipe, if there is a clogging phenomenon, the condensed water will flow into the water tank.
- Do not bend the drain pipe. The height of the drain pipe should be lower than the outlet.
- The drain pipe must be securely connected to the outlet.
- The appliance must be installed, operated and stored in a room with a floor area larger than 4 m2