PRODUCER:

ISO TRADE Spółka z o.o.
Gniewomierz 173
59-241 Legnickie Pole, Polska

office@iso-trade.biz

RESPONSIBLE PERSON IN THE EU:

IsoTrade

WARNING CONTENT:

- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
- The device must be disconnected from the power supply during maintenance.
- Always operate the appliance from a power source with the same voltage, frequency and rating as indicated on the product nameplate.
- Always use a grounded electrical outlet.
- Unplug the power cord when cleaning or not in use.
- Do not operate the device with wet hands. Avoid spilling water on the device.
- Do not immerse or expose the device to rain, moisture or other liquids.
- Do not leave the device switched on unattended. Do not tilt or turn the device.
- Do not disconnect the device from the power supply when it is turned on.
- Do not disconnect the device from the power supply by pulling on the power cord.
- Do not use an extension cord or adapter.
- Do not place objects on the device.
- Do not climb or sit on the device.
- Do not insert fingers or other objects into the air outlet.
- Do not touch the air inlet or aluminum fins of the device.
- Do not use the device if it has been dropped, damaged or shows signs of product malfunction.
- Do not clean the device with any chemicals.
- Make sure the device is away from fire, flammable or explosive objects.
- The device must be installed in accordance with national wiring regulations.
- Do not use means to accelerate the defrosting or cleaning process other than those recommended by the manufacturer.
- The appliance should be stored in a room without any sources of continuous operation (for example: open flames, an operating gas appliance or an operating electric heater).
- The device should be stored in a way that prevents mechanical damage.
- Do not divide into pieces or burn, even after use.
- Please note that refrigerants may not have an odor.
- Pipelines must be protected from physical damage and should not be installed in an unventilated space if that space is less than 4 m2.
- National gas regulations must be observed.
- Keep all required ventilation openings clean.
- The device should be stored in a well-ventilated room, where the size of the room corresponds to the area of the room designated for operation.
- Do not throw away the water tank magnets and plastic rivets. Otherwise, the unit will not stop automatically when the water tank is full, and condensed water will spill out and damage the floor.
- Before resetting the device, clean the condensed water in the water tank.
- If the water tank is dirty, rinse it with clean water. Avoid using detergents, steel balls, chemical dust removers, diesel fuel, benzene, thinners, or other solvents. Otherwise, the water tank will be damaged and may leak.
- Place the empty tank back into the device. Otherwise, the water full indicator may remain red and the device may not restart.
- Do not block the drain or drain pipe if the clogging phenomenon causes condensed water to flow into the water tank.
- Do not bend the drain pipe. The height of the drain pipe should be lower than the outlet.
- The drain pipe must be securely connected to the outlet
- The appliance must be installed, operated and stored in a room with a floor area larger than 4 m2